 |
|
TD-150A Digital Differential
Manometer equipment with high
performance amplifier and
semi-conductor sensor. The wide
range covers from vacuum to low
pressure. This type is very
economically disigned and can be
used for all of the applications
and also. It is matching sensor
technology and low cost. |
 |
|
 |
•
Alarm : 1 point relay contact
•
Small Size(75mm), light weight and low
cost
•
Wide temp ranges and high quality
•
Duraility for ripple and vibrations
• AC
220V Power(Option : 110V)
•
Actural Unit : Measuring Unit, % mode
change
•
0.25% Accuracy and Autozero function
|
|
 |
|
DISPLAY |
4 Digit LED |
|
TYPE |
D TYPE, (Option : BD type) |
|
ACCURACY |
¡¾ 0.25%F.S |
|
WORKING PRESSURE |
400%F.S |
|
TEMPERATURE |
-20 ~ 80¡É |
|
HUMIDITY |
0 ~ 90% R.H |
|
APPLICATION GAS |
Air, Gas |
|
SENSOR MATERIAL |
Silicon Diaphragm |
|
PROCESS CONNECTION |
4mm Hose |
|
PRESSURE RANGE |
Pressure Unit |
kgf/§², Pa, PSI, mmH2O, mmHg,
mbar, % |
|
Gauge Pressure |
10,100,500,1000,3000,5000mmH2O..10kgf/§² |
|
Compound Pressure |
¡¾5, ¡¾10, ¡¾300, ¡¾500, ¡¾760mmHg |
|
CONTROL OUTPUT |
Relay Output Contact 1 Point |
|
POWER SUPPLY |
AC 220V ¡¾10% 60Hz (Option :
AC110V , DC 24V) |
|
ACCESSORY |
Panel Mounting Bracket, 4 ¡¿ 6mm
Hose 1.5Meter(Option) |
|
WEIGHT |
Approximately 480g |
|
CASE MATERIALS |
ABS |
|
|
 |
 |
|
 |
 |
|
 |
Instrouction
for key operating set and method
¡¡
 |
In the setting menu when you
pressure value increase pages
and press the button increase
digit one by one |
 |
In the setting menu when you
pressure value decrease pages
and press the buttondecrease one
by one (Gradually) |
 |
If you enter setting menu, press
the
same time or press the
synchronous, the
setting menu are divided |
Setting munu
procedure and instruction function
|
C - S |
This is relay contact at setting
point and normal condition
contact point is ON position and
reaching setting value if must
be OFF
If
and
will be pressed same time marked
C - S at display window and
after adjust without key input
there is displayed END and
finised. |
|
D - T |
This is pressure difference
signal in the differential
pressure appear to DISPLAY
window to set time, and if will
be set from 0(Zero) to 10(Ten),
If zero is very fast operating
and increase one by one.
Then display speed is lower, If
and
will be pressed same time.
Marked D - T at display window
and after without key input.
There is displayed END and
finished. |
D - T
ADJUST |
If sensor used long time. There
is a some error output.
Then
key press 3sec. it automatically
adjust zero point and
compensated output error
deviation. |
|
|
Water Ionizer
